Nissan logo flow through badge for the 370Z
Larger-Than-OEM Badge Size
Printed out of ASA for heat and UV resistance, this modernized Nissan badge allows additional airflow through the upper logo on the Z bumper.
Letters float in the center of the badge, maximizing air pass-through. The emblem is slightly larger than the OEM badge to allow more air flow as well.
For OEM badge sizing, purchase here: Nissan Flowgo (OEM Size) – 370Zed
Fitment has been verified on the following:
- Nismo V1 Bumper
- Non-Nismo Bumper
Backing plate options:
- Flow air straight back (most CAIs)
- Direct air left and right (OEM airbox or short ram
- Direct air to the right, driver's side (https://370zed.com/products/370z-rotrex-center-intake-kit)
Colors:
- Black
- Black with Dark Gray lettering (+$10)
Install:
- Remove bumper
- Create a 4.75" hole (use a 4.75" hole saw). Center the hole saw centering bit just below the center of the existing logo (center identified by small thicker square of plastic).
- Insert front plate, and line up and tighten rear plate. If loosening over time, add a slight bit of slow acting adhesive to the outer ring of the front plate.